Dear fellow QNX developers,

I am running QNX on different Gumstix on a Tobi-Board, since I received newer Gumstix with u-Boot 2010-12 I am not able 
to load the QNX image. 

Here are the changes discovered so far:

In U-Boot 2010-12 the MMC is available under mmc 0 and not anymore under mmc 1. 
The mmc init does not allow to load the image into the ram, since fatload doesn’t recognize the mmc. After mmc part 0 
fatload is able to detect the partition.But after loading the image into the Ram the Gumstix reboots when calling the 
address. 

The Image does boot without any Problems on a different Gumstix with u-Boot 2010-09.

Are there any sugesstions to be able to run the image, maybe without flashing a new u-Boot?

Thanks in advance